Matthew Calderon

If the volume knob has never worked, or worked but quit shortly after installation, follow these steps to correct the problem.Start the vehicle.On the radio, navigate to Settings / Load Defaults.Se...

When using a PAC module on a Stinger radio whether it is the Heigh10, IE268, GX3800/3900.You will set the module's Rotary dial to (4) for Clarion, or if the module has dip switches, you will set di...

Follow these steps to troubleshoot the issue.Does the vehicle have a factory amplifier or subwoofer?If yes, the connector/port labeled "amplified" should be used.If no, the connector/port labeled "...

If some of the gauges in the radio are missing, this is caused by the PAC CH1A-SRK module losing partial communication with the vehicle. A temporary fix to get the gauges working again is to reset ...

When you are installing the Heigh10 with an SR or SRK kit is good to know what wires will need to be used for when adding cameras. For kits like the SR-TAC16H, SR-RUN10H, SR-TUN14H, SR-GM14H, SR-F1...

This article explains how to add the SwitchHUB to a Stinger radio equipped with trigger outputs.Applicable radios: Heigh10+, Horizon10, Horizon12, SPXM1Installation StepsGrounding: Connect a proper...

The SwitchHub is a solid-state relay hub with 4 independent outputs: one 40-amp and three 20-amp, totaling 100 amps of continuous current. Each output can be triggered independently by positive or ...

If Sirius radio isn’t working, follow these steps to figure out why. Is the SiriusXM icon on the radio grayed out? Did you purchase a SiriusXM tuner? A SiriusXM tuner is required to retain SiriusXM...

If the gauges only work partially, it may be due to missing CAN data. To fix this, reset the PAC RadioPro CAN data interface using one of two methods. Both require the Jeep to be running.Applicable...

All Stinger radios feature an internal microphone and do not require an external one, except for the Horizon12.Note: For Horizon12 installations, the microphone is integrated directly into the kit'...