If the gauges are only partially working, this may be due to missing CAN data information. To solve this problem, reset the PAC RadioPro CAN data interface. There are two different methods for resetting the interface. Both methods require the Jeep to be running.
Method 1
- With the PAC RadioPro interface visible, locate the blue program button on the side of the interface.
- Press and hold the program button until the LED blinks red and then let go. The radio and PAC interface will reboot. After the radio reboots, the gauges should be working.
Method 2
- Navigate to the Installer Settings on the radio.
- For the Heigh10: settings / system settings / installer settings (0052) / advanced vehicle settings / about /
- For the Heigh10+ and Horizon radios: settings / installer (top right tab) / PAC advanced settings / Application Info /
- Select “Factory Reset” on the RadioPro.
Comments
0 comments
Article is closed for comments.