Matthew Calderon

This article explains how to add the SwitchHUB to a Stinger radio equipped with trigger outputs.Applicable radios: Heigh10+, Horizon10, Horizon12, SPXM1Installation StepsGrounding: Connect a proper...

The SwitchHub is a solid-state relay hub with 4 independent outputs: one 40-amp and three 20-amp, totaling 100 amps of continuous current. Each output can be triggered independently by positive or ...

The following links are for the various PAC update utility tools for performing firmware updates and configuring vehicle settingsAmpPROUtility ToolBCIUtility ToolRadioPROUtility ToolSearch Keywords...

Follow these steps to troubleshoot the issue.Does the vehicle have a factory amplifier or subwoofer?If yes, the connector/port labeled "amplified" should be used.If no, the connector/port labeled "...

The links below provide manuals for Stinger radios. These are not the vehicle-specific kit manuals. For those manuals, please visit the product page. The product registration form is also listed he...

All Stinger radios feature an internal microphone and do not require an external one, except for the Horizon12.Note: For Horizon12 installations, the microphone is integrated directly into the kit'...

If your factory Bose system has no audio with a PAC module, the amplifier turn-on circuit may be overloaded. These vehicles have 3 amps and an antenna booster. Follow these steps to fix the issue.A...

If you are experiencing GPS issues with a Stinger radio, follow the troubleshooting steps below to sort out the problem.Can the GPS antenna see the satellites in the sky?The GPS antenna shouldn't h...

If the radio doesn’t activate the backup camera screen when the vehicle is in reverse, it may indicate that the reverse wire has not been properly connected. On the radio-side harness of the PAC in...

The DIP switches on PAC interface modules are product-dependent. These switches dictate module behavior and identify the specific radio or vehicle for the installation.Important: Always refer to th...