Matthew Calderon

If the kit is not working correctly, please follow these steps to resolve the issue.Applicable Kits: JK11RB12, SRK-JK11H, SRK-JK11HX, SRX-JK11128, RB10JK11K, RB10JK11HP, RB10JK11XOpen the hood and ...

This example tutorial is for Feature Set 6, delaying an amp turn-off for 10 seconds. Other times can be used, but a 10 second delay is the simplest as it only requires one press for timer programmi...

If the Voice button on the steering wheel doesn’t enable Google Assistant or Siri, follow these steps for troubleshooting. Inspect the LED light on the PAC RP4-FD11 “blue box” interface. Does it fl...

This video will show you how to set up the many different camera triggers and their settings on the Stinger Heigh10 when used with the SRK-JK11EH kit in your Jeep JK.

This example tutorial is for Feature Set 12, delaying an amp turn-on for 10 seconds. Other times can be used, but a 10 second delay is the simplest as it only requires one press for timer programmi...

This video will show you how to set up the many different camera triggers and their settings on the Stinger Heigh10 when used with the SRK-JW18EH kit in your Jeep JL / JT.

If the aftermarket radio uses a 3.5mm jack for steering wheel control and the buttons are mixed up, this could be due to the jack slipping out or contaminants on the jack. Unplug the jack and then ...

The LPH T-harness allows you to install aftermarket amplifiers without modifying the factory harness. The LPH T-Harness is intended for use with a line output converter (LOC), but can also be conne...

If the steering wheel control (SWC) buttons do not work with a PAC RadioPro interface, follow these steps to correct the problem.Verify the connections:Make sure the correct steering wheel connecti...

Instructions on how to look up your vehicle, set up your module, and understand the wiring page in the video below. This applies to any of the following modules:  SWI-RC-1, SWI-CP2, SWI-CP5, C4RAD,...