The DIP switches on PAC interface modules are product-dependent. These switches dictate module behavior and identify the specific radio or vehicle for the installation.
Important: Always refer to the specific installation manual included with your product. If you are installing a steering wheel control interface, please follow the dedicated online guide.
Set Before Powering: DIP switches must be configured before applying power to the interface module.
- Note: If power was applied before settings were adjusted, unplug the module, and reconnect.
Pre-programmed Modules: If the product instructions do not mention configuring DIP switches, the module is pre-programmed, and no further action is required.
Example 1 (DIPs set on)
Example 2 (DIPs set off)
Comments
0 comments
Article is closed for comments.